During our drafting work, we do a lot of copy & pasting from one drawing to another. sometimes we need to past some objects into our current drawing on the original coordinates on which it was drawn in the source drawing.
PASTEORIG
Using this command, objects copied into the clipboard will be pasted into the drawing at the same coordinates used in the source drawing. The only condition is, the source drawing should not be the current drawing.
In your source drawing select & copy your objects with ctrl+c go to your target drawing and on command line type PASTEORIG. Press enter & you are done.
Thanking You,
- Abhay Chauhan
PS : Don't forget to comment and share the post with your friends.
PASTEORIG
Using this command, objects copied into the clipboard will be pasted into the drawing at the same coordinates used in the source drawing. The only condition is, the source drawing should not be the current drawing.
In your source drawing select & copy your objects with ctrl+c go to your target drawing and on command line type PASTEORIG. Press enter & you are done.
Thanking You,
- Abhay Chauhan
PS : Don't forget to comment and share the post with your friends.
No comments:
Post a Comment